Operation; Battery Level - Rebel Rb-1000 Bedienungsanleitung

OPERATION

Note: The battery is partially charged. To ensure proper operation of the power tool,
the battery must be fully charged before first use.

Battery level

Indicators in the upper part of the grip inform about the battery level.
• When the battery is fully charged, all three LEDs- green, yellow and red are on.
• When the battery is half empty, two LEDs- yellow and red are on.
• When the battery is empty, only red LED is on. Charge the battery immediately.
Charging
• Place the AC charger on a flat and stable surface within about 1 meter from the power
supply socket.
• Remove the battery from the power tool. Press and hold the battery release button (8)
and at the same time slide out the battery.
• Slide the battery to the AC charger maximally so that it locks in place.
• Connect the AC charger to the power supply socket.
• When the battery is fully charged, slide it out from the AC charger and slide it in the
power tool so that it locks in place.
Charging indicators
The AC charger has charging indicators which indicate the status of the charging process:
LED
Red
Green
• It takes about 1,5 hour to fully charge the battery.
• AC charger and battery may heat up during charging. It is a normal behavior.
• When power tool is not in use, it is recommended to charge the battery every three
months.
• When you notice that the power tool performance is decreasing, recharge the battery.
Fitting and removing drill bits/screwdriver bits
To fit/remove a drill bit/screwdriver bit:
• Set the rotation direction switch (7) to the middle position.
• Rotate the sleeve right to open the chuck jaws. Place the drill bit/screwdriver bit as far
as it will go in the chuck (1), then rotate the sleeve left to tighten the chuck.
• Rotate the sleeve right to open the chuck jaws what allows to remove drill bit/screwdriver
bit safely.
EN
Battery charging in progress
Battery charging finished, battery fully charged
52
Status