Rebel RB-1000 Bedienungsanleitung Seite 49

cause burns or a fire.
9. Under abusive conditions, liquid may be ejected from the battery. Avoid contact.
If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the battery may cause irritation or burns.
10. Do not use damaged or modified batteries. Damaged or modified batteries may
behave in an unpredictable manner, resulting in hazardous effects (ignition, explosion,
personal injuries).
11. Ensure that the switch is in the OFF position before inserting the battery. Inserting
the battery into power tools with the switch on invites trouble. Injury hazard.
12. Charge battery pack only at ambient temperatures between +10°C and +40°C. Store
the battery in a dry location protected from cold where temperature would not
exceed +40°C.
Charger use and care
1. Do not attempt to open or disassemble the charger. If the charger has been dropped
or is damaged in any way, stop using it and do not attempt to repair it. Return the
charger for repair to an authorized service center or a qualified person, to avoid any
danger to the user; or discard it according to local laws.
2. Protect the charger against any heat source (e.g. direct sunlight exposure, fire,
heater) to prevent any damage to the charger.
3. Do not expose the charger to water, moisture and cold. Risk of electric shock.
4. If the power cord or the plug becomes damaged, stop suing the charger until it
has been repaired by a qualified person. If the supply cord is damaged, it must
be replaced by the manufacturer or its authorized service center, in order to avoid
a hazard. Risk of electric shock.
5. Only use the charger provided with the tool, or a same type or same model charger
to charge the battery. The use of other types of charger increases the risk of electric
shock, personal injury and damage.
6. Never attempt to recharge non-rechargeable batteries. Explosion hazard.
7. Only use the charger at ambient temperatures between +10°C and +40°C. Store
charger in a dry location protected from cold where temperature would not exceed
+40°C.
8. The charger is intended for indoor use only. Place charger on solid, flat non-
flammable surface and away from any flammable materials when re-charging the
battery pack.
9. Do not recharge the battery pack in a wet or humid environment. The charger and
battery pack may heat during charging process.
Additional safety warnings for drill
• Hold the power tool with a firm grip with both hands (if possible) and keep a good
balance. The tool is best guided with both hands. If bit gets locked, a strong torque
reaction may occur when screwing in or loosening screws.
• Use appropriate detectors to determine if utility lines are hidden in the work area or
call the local utility company for assistance. Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can lead to explosion. Penetrating a water line
49 EN