Operation Mode Description - Optimum Time OS Serie 7 Anleitung

Operation Mode Description

Time Mode
How to set the time :-
Use the [MODE] button to get to the real time mode. (The word
TIME will appear)
Please note: With this watch, it is necessary to set the seconds before the hours and
minutes. You will need to know the actual time of day locally.
Enter the time-setting mode by pressing the [CLEAR] button and hold it down for
approximately 2 seconds until a beep is heard. Once in the time setting mode, the second
display begins to flash and the upper line shows the word "SEC".
Find the real time locally (maybe from the speaking clock or teletext), and when the real
time locally reaches zero seconds (after seconds 57, 58, & 59), press [PROG] to reset the
"Second" digits to zero. i.e. Do this when the real time of day reaches a full minute.
NOTES :
Each piece of data to be changed is accessed via the [MODE] button and altered
via the [PROG] button. The watch will automatically leave the setting mode if no key is
pressed for 1 minute.
After adjusting the "Second" digits, press [MODE] to proceed to the next item. This will
be the HOUR setting and is altered by pressing the [PROG] button. The setting sequence
is in the order of second, hour, minute, year (available from 2005-2099), month, date,
12Hour/24Hour, Month-Date or Date-Month, and Beep On/Off. (With the beep on, every
time you press a button it will beep, with the beep off, the watch will be silent except for
the countdown timer alarm – this is silenced a different way – see later). You can repeat
around the sequence again by pressing [MODE] more times. Press [PROG], to increase
each chosen setting in individual increments. Pressing and holding the button for 2
seconds will activate the fast setting.
Once all values are correct, confirm all settings by pressing [CLEAR]. This will also return
to the Time mode.
The watch will automatically leave the setting mode if no key is pressed for 1 minute.
I n s t r u c t i o n s
6
E N G L I S H
Alarm Mode
One daily alarm is available. Press [MODE] until you enter the Alarm mode. The dot
matrix panel shows the word "ALARM" and the alarm time is displayed in the middle
bigger digits while the lower display shows the real time clock.
To switch the alarm on, press [START/STOP] while in the alarm mode. When the alarm is
enabled, the icon will be displayed together with the message "On". To turn it off
simply press [START/STOP] one more time
When the real time reaches the alarm set time, a 30 second alarm sound will be
generated (as long as the alarm is on). You can press any key to stop the alarm sound.
How to set alarm time :-
Enter the setting mode as described. Press [CLEAR] and hold it for 2 seconds to activate
setting (a beep is heard). Setting starts with hour digits which are seen flashing.
Use [PROG] to alter the hour digits. Then move to minute digits by pressing [MODE].
Adjust the minute digits with [PROG] as well. Finally, press [CLEAR] once to exit setting
and confirm the chosen alarm time.
NOTE: Whenever the alarm time is changed, the alarm will be automatically enabled. If
you want to set the alarm time, but do not want it to go off, you must turn it off.
Sailing Timer Mode
Press [MODE] in until you go to the Timer mode. The dot matrix panel shows the word
"TIMER"
The big digits show the timed period in minutes and seconds. The smaller digits show the
RTC on the lower row.
The default pre-programmed timing sequence for the watch is "5-4-1-0" minutes.
Once in Timer mode, there are three counting options you can select. They are: Count-
Up, Count-Down and Up, and Count-Down Repeat.
E N G L I S H I n s t r u c t i o n s
7