Milnor Mark II Betriebsanleitung Seite 12

>_b]Q\?`UbQdY_^±=Qb[99
DY\d D_ E^\_QTGQcXUb 5hdbQSd_b
41>75B*5h`\_cY_^Q^T6YbU8QjQbTc
5[P\\PQ[T bdQbcP]RTb RP] Tg_[^ST ^a XV]XcT X] cWT Rh[X]STa SaPX] ca^dVW ^a
bTfTa  CWT \PRWX]T Xb STbXV]TS U^a fPbWX]V fXcW fPcTa ]^c P]h ^cWTa b^[eT]c
?a^RTbbX]VRP]RPdbTb^[eT]c R^]cPX]X]VV^^Sbc^VXeT^UUU[P\\PQ[TeP_^ab
3^]^cdbTU[P\\PQ[Tb^[eT]cbX]_a^RTbbX]V
CW^a^dVW[hU[dbWP[[U[P\\PQ[T b^X[TSV^^SbfXcW\d[cX_[TR^[SQPcWbQTU^aT
P]hW^cQPcW 2^]bd[cfXcWh^da[^RP[UXaTST_Pac\T]c _dQ[XRbPUTch^UUXRTP]S
P[[X]bdaP]RT_a^eXSTab
Separate tangled linen.
Size loads as determined locally. Overloading may reduce wash quality. Under loading may inhibit
extraction.
Manual door— Swing the door closed with enough force to latch it.
Power operated door— Simultaneously hold the Door Open button (
Door switch to close (
NOTE: Closing the door sounds the operator signal if a formula was previously selected.
depending on the optional hardware furnished and the formulas used. The possible methods are as
follows:
Automatically inject chemicals with a pumped chemical or central liquid supply system.
Load the supply injector before starting the cycle. Supplies are flushed in automatically.
Re-load supply injector compartments or manually flush compartment one during the cycle,
when prompted by the formula.
Pour supplies through the soap chute before or during the cycle.
Because the injection method, formulas, and chemicals to be used are determined in the field,
the operator procedures for adding chemicals are determined locally. See the reference manual for
further information on the optional supply injector, liquid supply injection, and formulas.
). Continue to hold until the door latches.
Chemical supplies may be added manually or automatically,
8
=C?E@<>?15 )$##1F# &
) and hold the Hydraulic