Kodak Ektalite series Bedienungsanleitung Seite 20

Using the Projector
4. Adjust the PROJECTION MIRROR'S angle to center the image on the
screen.
5. Adjust the FOCUS KNOB up or down on the ARM to see the image
clearly.
6. When the lamp is burned out, use the LAMP CHANGE HANDLE to
switch to new lamp. Model E12 only.
The power is cutoff automatically during lamp change; switch power on
again after using lamp switch.
NOTE:
Remember to replace the old lamp with a new one before next use.
Do not remove lamp until it is completely cooled.
18
KODAK EKTALITE E10/E11/E12 OVERHEAD PRO-