Safescan 155 serie Handbuch Seite 4

8. If the banknote is genuine, the screen will display the denomination or the value and the number of
sheets of the banknote(s) tested. This depends on the selected detecting mode,
see chapter 2.2 for details.
9. If a suspected banknote is detected, the machine will beep and an error code will appear in the display.
See table 1 for suspected banknote error codes.
10. To view the counting results, press the [report/Dir] key (2). See chapter 2.4 for details.
11. Press [On/Off- clear] key (1) for 2 seconds to Power Off the machine.
Table 1
suspected banknote error codes:
E01
E02/E03
E04/E05
E06
E07
E08
E09/E10/E11/E12
E20
2.1 recharging the battery
The battery will automatically recharge when the machine is connected to the power socket. At start up, the battery
indicator will blink on the screen. The status of the battery power can be defined by analysing which segments of the
battery icon are blinking.
1. Device works on adapter: Battery is being charged while battery is not full
After start up: Segment A is on. Segment B + C are blinking. (first B for 0,5 sec. and then C for 0,5 sec.)
This happens 5 times in 5 seconds. After 5 seconds the whole battery icon disappears.
2. Device works on adapter: Battery is being charged while battery is full.
After start up: Segment A + B + C are blinking 5 times together in 5 seconds.
After 5 times blinking the whole battery icon disappears.
3. Device works on battery: If battery power is less than 20%.
After start up: Segment A + B are blinking together. Blink speed is 1 time per sec.
4. Device works on battery: If battery power is 50% full.
After start up: Segment A+B are on. After 5 seconds the icon disappears.
4
Banknote length unconformity
Magnetic properties unconformity
Infrared properties unconformity
Banknote thickness unconformity
Slant note
Security strip unconformity
Watermark unconformity
Passing Error
(battery sold seperately)