Mounting The Camera - Hawke 46 102 Bedienungsanleitung

the "OFF" position when installing or removing the SD card. Insert the SD card and fully depress
until it clicks (an icon depicts SD card loading direction inside the camera). To remove the SD card,
depress until it clicks and is ejected.
The SD card must be clean (no images from other sources). If you are using the SD card from
another camera, please make sure to format the SD card prior to using in the camera.
CAMERA MODE
The camera has three capture modes: "PHOTO", "BOTH" and "VIDEO". These are selected using
the switch below the camera's display screen. When the switch is in the "BOTH" position the
camera will take a still image at the start of every video recording.
PIR SENSITIVITY (MOTION DETECTION)
The camera has three PIR sensitivity settings: "H" (high), "M" (medium) and "L" (low). The PIR
switch is located under the display screen. If you want the camera to detect long distance targets
or small animals, use the "H" (high) sensitivity setting.

MOUNTING THE CAMERA

The camera should be mounted approximately 1.2 to 1.5 meters off the ground with the camera
pointed at a slight downward angle. Avoid mounting the camera facing east or west as the rising
and setting sun can produce overexposed images. Ensure the camera lens and PIR sensor (motion
detector) are not blocked by any branches or debris.
6