Hawke 46 102 Bedienungsanleitung Seite 4

QUICK START
A.
1. Insert SD card and 8x AA batteries.
2. Push the power switch into the "ON" position.
3. The main menu will be displayed on screen.
4. Use the arrow buttons to highlight the SETTINGS menu and press "OK".
5. Navigate through the menu using the up, down, left and right arrow buttons.
6. Press the "OK" button to select the highlighted option. Make changes to its setting using the
arrow buttons. Press "OK" to confirm and save the setting.
7. Once all settings have been confirmed press the "SETUP" button to return to the main menu
screen.
8. The camera has three capture modes: "PHOTO", "BOTH" and "VIDEO". These are selected
using the switch below the camera's display screen. When the switch is in the "BOTH" position
B.
the camera will take a still image at the start of every video recording.
9. The camera has three PIR sensitivity (motion detection) settings: "H" (high), "M" (medium) and
"L" (low). The PIR switch is located under the display screen. If you want the camera to detect
long distance targets or small animals, use the "H" (high) sensitivity setting.
10. Use the arrow buttons to highlight CAMERA and press "OK". The display will turn off and the
camera is ready to capture photos/videos.
11. Place the camera in the desired location with a clear view of the intended target.
• Ensure the power switch is in the "OFF" position when not in use.
4