Hawke 46 102 Bedienungsanleitung Seite 10

Working Mode
Working mode is used to set the camera's activation to PIR (motion detection), time-lapse or a
combination of both. PIR: The camera works on PIR activation. Time Lapse: The camera takes an
image at certain intervals of time. The interval time ranges from 1 minute to 24 hours. Both: The
camera uses both PIR and time-lapse modes. SETTINGS – Basic (default) – Working Mode – Use
the left and right arrows to move between PIR, Time Lapse and Both – Press "OK" to confirm.
If you select Time Lapse or Both, you can set the time lapse interval using the TL Interval setting
in the Advance menu (can be set from 1 minute to 24 hours).
SETTINGS: PHOTO
Day Photo Size
Sets the image quality for photos captured in daylight from 5MP, 8MP or 14MP. SETTINGS –
Photo – Day Photo Size – Use the left and right arrows to move between 5MP, 8MP and 14MP
– Press "OK" to confirm.
Day Photo Num (Burst)
Captures a burst of images every time the camera is triggered. SETTINGS – Photo – Day Photo
Num – Use the up and down arrows to move from 1P (1 image) to 10P (10 images) – Press "OK"
to confirm.
10