Connection To Input2; Connection To Input3; Connection To Input4 - Pioneer PDA-5004 Bedienungsanleitung

Connection to INPUT2

A computer equipped with DVI output (digital RGB signal) or
an AV component equipped with DVI output (PDP-505CMX/
PDP-50MXE10/PDP-50MXE11 only are supported), can be
connected to the plasma display's DVI connector (HDCP-
compliant).
INPUT2
DIGITAL RGB AUDIO
DVI-D
Computer or AV component
On-screen setup is necessary after connection.
Please see pages 18 to 21.
Notes
¶ Use a DVI-D 24-pin (digital only) cable for the connection.
¶ PDP-504CMX/PDP-50MXE1/PDP-50MXE1-S and PDP-
434CMX/PDP-43MXE1/PDP-43MXE1-S do not support the
display of copyguard-protected video signals.
NOTICE
¶ INPUT2 is compatible with Microsoft's Plug & Play (VESA DDC
2B).
¶ For screen sizes and input signals compatible with INPUT2,
please refer to the plasma display's Operation Instructions or
Appendix 1 of this Operating Instructions (PDP-505CMX/PDP-
50MXE10/PDP-50MXE11 only).

Connection to INPUT3

Connect an AV component that has S-video output jack to
the video card's S-VIDEO (INPUT3) jack.
INPUT3
S-VIDEO
AV component
Installation and Connections

Connection to INPUT4

Connect an AV component that has a video output jack to
the video card's INPUT4 jack. The VIDEO OUT (INPUT4)
jack can be used to output the video signal to a separate
monitor, recording device or other component with video
input capability.
Note
A video signal will not be output from the VIDEO OUT (INPUT4)
jack when the main power of this display is off or in standby
mode.
[When using PDA-5003]
INPUT4
VIDEO
IN OUT
[When using PDA-5004]
INPUT4
VIDEO
IN OUT
Signals to the INPUT3 and INPUT4 jacks are all
compatible with the following TV systems: NTSC, PAL,
SECAM, 4.43NTSC, PAL M and PAL N. For details,
please refer to "Setting the COLOR SYSTEM" on page
40.
To a monitor or a
recording device
AV component
To a monitor or a
recording device
AV component
13
En