Herunterladen Diese Seite drucken

Troubleshooting - Swim & Fun SPS50-1 Bedienungsanleitung

250/450/550 watt

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 32
• Always use heavy duty 1.5 mm2 extension leads. Always roll out cable reels to FULL extent.
• NEVER fasten, crush, pull or drive over electrical cables and extension leads. Protect leads
from sharp objects.
• Place extension leads well AWAY from the water to be pumped.
• Never use a damaged cable. It should be replaced by the manufacturer, an authorised
service centre or a qualifi ed technician.
• Remove plug from socket before servicing the pump.
• This pump is not intended for use by anyone (including children) who has impaired physical,
sensory or mental capacity or anyone who lacks the required experience and knowledge,
except under supervision or after training in the use of the device by a person, who is also
responsible for their safety.
• Keep a watchful eye on children: Never allow children to play with the device.
Dangers in connection with pump failure
• If you observe that the pump has been damaged in transit, notify your supplier immediately.
Do not use the pump!
• Before using the pump, check the pump, and especially the electrical cable and plug, for
defects and damage. Risk of fatal electric shock!
• A defective pump must be repaired by a qualifi ed technician. Never use a defective pump!
• Never attempt to repair a pump yourself! Only qualifi ed specialist technicians are permitted
to service and repair pumps and pressurised containers.
8.

Troubleshooting

The pump does not suck properly or is very noisy.
• Insuffi cient water: Make sure that the water supply is adequate.
• The suction hose is leaking: Seal hose connectors with Tefl on tape and tighten hose clamps.
• The pump is not at the same level as the pool bottom (it should always be level with pool
bottom).
• Filter basket inside the pump is blocked.
Rate of suction too high
• Never exceed maximum rate of suction(See Hmax in technical specifi cations). The pump
should always be level with the pool bottom.
Pressure is too low:
• The suction hose is leaking or suction rate too fast (See Hmax in technical specifi cations):
See above.
MV-1634-1018-1019-11-2015 . Swim & Fun Scandinavia . info@swim-fun.dk . www.swim-fun.com
© All rights reserved Swim & Fun Scandinavia ApS 2015
Side 5

Werbung

loading

Diese Anleitung auch für:

Sps100-1Sps75-1