Voice Function; C-Cdc / R-Cdc / T-Cdc; Name - Nome; Technical Specifications - Midland G18 Bedienungsanleitung

VOICE function

With this function, you activate a voice that informs you about any operation/se-
lection you are doing.
To activate it, follow these steps:
1. Press the MENU button;
2. Turn the Encoder knob until "VOICE" is displayed;
3. Push ENT to enter the function;
4. Turn the Encoder knob to activate/deactivate the function: "ON" (to activate
it), or "OFF" (to deactivate it);
5. Confirm your selection with ENT.

C-CDC / R-CDC / T-CDC

The CTCSS tones can be added to the channels for creating new private channels.
They are similar to access codes and enable the radio to communicate only with the
users that are tuned on the same channel and have set the same code. For each
channel you can set up to 50 CTCSS tones and 105 DCS codes.
To select a CTCSS tone:
1. Press the MENU button;
2. Turn the Encoder knob till "C-CDC"(in TX and RX); "R-CDC"(only in RX) or
"T-CDC" (only in TX) appears on the display;
3. Push ENT to enter the function;
4. Turn the Encoder knob and select the desired CTCSS tone
5. To confirm, press the ENT button.
The setting of a CTCSS tone disables all DCS codes, because these functions cannot be
used simultaneously.
If you want to use and select a DCS code, instead of a CTCSS tone, follow these steps:
1. Press the MENU button;
2. Turn the Encoder knob till: "C-CDC"(in TX and RX); "R-CDC"(only in RX) or
"T-CDC" (only in TX) appears on the display;
3. Push ENT to enter the function;
4. Press the Function key 1;
5. Turn the Encoder knob and select the desired DCS code;
6. Confirm the selection by pressing the ENT button.
The setting of a DCS code disables all CTCSS tones, because these functions cannot be
used simultaneously.

Name - Nome

It is possible to choose and set a name that will appear on the display instead of the
channel number.
14 | Midland G18 instruction guide

Technical specifications

General
Frequency range 446.00625- 446.09375 MHz (PMR446)
Channels 8 +91 pre-set
Working temperature -20°+55°
Operating voltage 7.4V
Operative Mode Simplex
Dimensions 113mm×56mm×38mm (Antenna excluded)
Weight 240g (Battery included)
Impedance Antenna 50Ω
Duty cycle 5/5/90%
Transmitter
Frequency stability ±2.5PPM
Output power ≤500mW ERP
Max frequency deviation ≤2,5KHz
Audio distortion ≤3%
Adjacent channel power < 60 dB
Spurious radiation Within European legal terms
Occupied bandwidth Within European legal terms
Receiver
RF sensitivity <0.2UV@20 dB SINAD
Audio distortion ≤3%
Audio response 300Hz ÷ 3KHz
Adjacent channel selectivity Within European legal terms
Intermodulation rejection Within European legal terms
Spurious emissions Within European legal terms
Blocking Within European legal terms
WARNING: Direct plug-in ac/dc power supply must be used for disconnecting the
transceiver from the mains; the desktop charger must be positioned close to the
unit and easily accessible.
Midland G18 instruction guide | 15