Maxwell MW-3250 R Betriebsanweisung Seite 10

ENGLISH
– there is no water in the dust container;
– the filtration block is not installed in the dust
container;
– the outlet НЕРА filter and all the foam rubber
filters are not installed.
• Make sure regularly that the power cord and
the plug are not damaged. If the power cord
or the plug is damaged or in case of improper
operation of the vacuum cleaner contact the
authorized service center.
• The unit is intended for household use only,
its commercial usage is prohibited.
KEEP THE MANUAL IN ACCESSIBLE PLACE
Safety measures
• Do not use the vacuum cleaner near hot
surfaces, ashtrays and in the places where
inflammable liquids are stored.
• Take sharp objects away from the floor before
cleaning to prevent unit damage.
• If the suction power of the vacuum cleaner
has decreased while cleaning, switch it off
immediately and check the telescopic pipe
and the flexible hose for obstruction. Switch
off the vacuum cleaner, unplug it, remove the
obstruction and after that you can continue
cleaning.
Assembling of vacuum cleaner
– Unpack the vacuum cleaner and check it for
damages. Do not use the unit in case of dam-
ages.
– Before switching on the unit, make sure that
your home electricity supply corresponds to
the operating voltage of the vacuum cleaner.
– Always switch off the vacuum cleaner and
unplug it while replacing the brush-attach-
ments and during preventive maintenance
activities.
Filling the dust container (19) with water
• Open the lid (3) pulling its edge (pic. 1).
• Remove the filtration block (20) by taking
the ledge on the block and pulling it upwards
(pic. 2).
• Fill the container (19) with water to the "MAX"
mark (pic. 3).
Note: The required
approximately 700 ml.
mw-3250.indd 10
water amount is
10
• Insert the filtration block (20) into the con-
tainer (19) (pic. 4).
• Make sure that the container (19) and the fil-
tration block (20) are installed properly.
• Close the lid (3) having matched the ledges
on the lid with the grooves on the body of the
vacuum cleaner, then press the lid for fixa-
tion (pic. 5.6).
Note:
- Do not exceed the "MAX" mark.
- Do not make excessive efforts while closing
the lid to prevent its damage or breakage.
Attaching and removing of flexible hose (10)
• Insert the flexible hose ending (8) into the
air inlet (7).
• Insert the hose according to the guideline
until fixation (click) (pic. 7).
• To remove the flexible hose press the clamp
(9) and take the hose out.
Attaching of telescopic hose (14) and
attachments
• Attach the telescopic extension pipe (14) to
the handle of the flexible hose (12) (pic. 8).
• Adjust the required length of the telescopic
pipe, having preliminary pressed the clamp
button (pic. 9).
• Select the required attachment: floor/carpet
brush (15), furniture brush (22), small brush
(23) or crevice nozzle (24).
• Attach the selected attachment to the tele-
scopic extension hose (14) (pic. 10).
Floor/carpet brush (15)
Set the switch on the brush in the required
position (depending on the type of the surface
being cleaned) (pic. 11).
Attachment holder (13)
Attachment holder (13) provides easy storage of
different attachments.
Fix the holder on the telescopic pipe as shown in
pic. 14 using the fixing screw.
Furniture brush (22)
The attachment is intended for cleaning of fabric
surfaces of upholstered furniture.
31.01.2013 15:27:41