Werbung
70 WLAN Access Points 2330/2330A/2330B
4
Plug a CAT-5 Ethernet cable (ferrite beaded for AP 2330) into the 2330/2330A/2330B access point and
attach the 2330/2330A/2330B to the mounting bracket.
Caution!
be installed in a location such that the device will be greater than 20 cm (8 in.) away from all
persons to ensure compliance with regulatory RF exposure requirements. Using higher
gain antennas and types of antennas not covered under the FCC certification of this
product is not allowed.
Configuring the AP
To configure the channels, power settings, and other 2330/2330A/2330B parameters, see the following:
Avaya WLAN—Security Switch 2300 Series Quick Start Guide
"Configuring a WSS for Basic Service" chapter in the Avaya WLAN—Security Switch 2300 Series
Installation and Basic Configuration Guide
"Configuring the AP Access Points" chapter in the Avaya WLAN—Security Switch 2300 Series
Configuration Guide
NN47250-303 (320662-G Version 02.52)
Cat 5e
Cable
Universal mounting bracket
When mounting the WLAN Access Point 2330/2330A/2330B, this device must
Lock
Werbung
Kapitel
