Instructions For Use - Bair Hugger 750 Betriebshandbuch

14

Instructions for Use

The instructions below describe how to operate the Model 750 temperature
management unit. For information about using Bair Hugger blankets or the 241
blood/fluid warming set with the Model 750 temperature management unit, refer to
the Instructions for Use included with each of these disposable components.
1. If the Model 750 temperature management unit is not mounted on an IV pole
or Bair Hugger rolling stand, place the unit on a flat, hard surface, such as a
table, before beginning temperature management therapy. Do not place the
temperature management unit on a soft or uneven surface, such as a bed, or
the air intake may become blocked and cause the unit to overheat.
2. Insert the end of the temperature manage-
ment unit's hose into the hose port of a Bair
Hugger blanket. Use a twisting motion to
ensure a snug fit.
3. Connect the temperature management unit to a properly grounded power
source. The unit will be operating in Standby mode and the Standby indicator
light will illuminate.
4. Press the appropriate button to select the desired temperature. When the unit
reaches the selected temperature, the Temp in Range indicator light will
illuminate; this indicator light does not illuminate in the Ambient mode.
5. Monitor the patient's temperature at least every 10 to 20 minutes, and adjust
the temperature setting of the temperature management system as required.
6. Press the Standby button when temperature management therapy is complete
and discard disposable components.
7. Unplug the temperature management unit to disconnect it from the power
source.
Bair Hugger Model 750 Temperature Management Unit Operator's Manual
Hose
Hose port