Technical Data; Items Supplied; Description Of The Appliance; Assembly - Lervia KH 4406 Bedienungsanleitung

• NEVER use the shredder for tasks for which it
was not designed.
• Always be attentive! Always pay attention to
what you are doing and act with common sense.
Never use the appliance when you are distracted
or don't feel well.

Technical Data

Mains voltage: 220-240 V ~ 50Hz
Rated current : 1,5 A
Protection class: II
CO Time: 15 minutes
Cutting process: Cross-cut, 4x41 mm-Particles
Working width: 240 mm
Slit depth corresponds to DIN EN 294
CO Time
The C.O. Time (Continuous Operation) details how
long an appliance may be used without the motor
overheating and being damaged. After the prescribed
C.O. time the appliance must be switched off for as
long as is necessary for the motor to cool down.

Items supplied

Paper shredder KH 4406
4 Rollers
4 Retaining caps
Instructions for use

Description of the appliance

q
Cutter attachment
w
Switch
e
Cutter opening
r
Viewing window
t
Waste receptacle
y
Rollers
u
Roller container

Assembly

• Insert the dowels on the rollers
on the underside of the roller container
• Push the retaining caps over the dowels from inside
to prevent them slipping back out.

Putting into operation

• First of all, place the cutter attachment
the roller container
is located at the rear, i.e. on the closed side.
• Push the waste receptacle
u
tainer .
• Connect the paper shredder to a power socket.

Operation

Switching the appliance on:
• Place the switch
When the appliance is ready, the green LED glows.
Note:
The Paper Shredder is fitted with a safety stop: If the
t
waste receptacle
inserted, the paper shredder will not start. In this
case, locate the waste receptacle
When the green LED glows you can operate the
Paper Shredder as usual.
Inserting paper:
• Insert paper from above and in portrait format
into the cutter opening
The motor starts automatically and switches itself
off automatically if no further paper is inserted.
You can shred up to 15 sheets (80g/m
at the same time.
- 15 -
y
into the openings
u
so that the power cable
t
into the roller con-
w
to the position for shredding.
is not inserted, or is not correctly
t
correctly.
e
.
-Paper)
2
u
.
q
onto