jbc ADVANCED-Serie Bedienungsanleitung Seite 4

Control Unit technical specifications
- Maximum power soldering iron 50W
- Maximum power desoldering iron 75W
- Power heating unit 900W
- Temperature selection of the soldering part :
100 to 371°C (±5%)
- Temperature selection of the desoldering part:
100 to 371°C (±5%)
- Temperature selection hot air:
150 to 455°C (±5%)
- Air flow regulation: 6-45 l/min
- Self-contained vacuum pump for holding ICs
- Station's maximum power: 1150W
- ESD protected housing.
Typical surface resistance: 10
- Complies with CE standards on electrical safety,
electromagnetic compatibility and antistatic
protection.
- Equipotential connector is earth connected to the
plug feed of the station.
- Weight of complete unit: 17.6 kg
- In the SOLD. connector you can only connect
handpieces 2010, 2210, 2045 and 2245 and the
hot tweezers PA 1200 and PA 4200.
- In the DESOLD. connector you can only connect
the desoldering iron DR 5600.
Safety measures
- Incorrect use of this tool may cause fire.
- Be cautious when using the tool in places
where inflamable products are stored.
- Heat can fire up inflamable products even
when they are not at sight.
- Do not use when the atmosphere is explosive.
- Place the tool back on its stand in order to let
it cool down before you store it.
5 11
-10 Ohms/square
3
OPERATION
Description of controls
- PEDAL:
Hot air is produced when it is held down.
Releasing it the heater is disconnected,
though the turbine continues to operate until
the air temperature falls below 100°C.
- BUTTONS:
Activates or desactivates the hot-air flow. After a
function-time of two minutes the hot-air flow
switches automatically off.
The red light indicates, that the heating element
is functioning. A malfunction is indicated by the
pulsing of the red led.
VACUUM
On/off switch for the self-contained suction pump.
The yellow light of the switch indicates that the
self-contained vacuum pump is activated.
- CONTROLS:
TEMPERATURE
Allows fixing the temperature of the heater
between 150 and 455°C. The selected
temperatures are reference values which may
change depending on the distance between
the heating element and the nozzle.
Allows fixing the temperature of the soldering
and desoldering iron between 100 and 371°C.
AIR FLOW
This enables the air flow to be set on a scale
from 1 (corresponding to the lowest setting
of 6 l/min) to 10 (corresponding to the highest
of 45 l/min).
- VACUUM SELECTOR:
Two vacuum inlets avalaible, being active
the one that coincides with the arrow.
ENGLISH
HEAT