Ethernet Configuration - OHAUS Scout Bedienungsanleitung

GlobalScientificSupply
www.
Ethernet Interface

ETHERNET CONFIGURATION

To set the Ethernet parameters per web.
1. Make sure the Ethernet Interface Kit is installed properly and network cable is
connected to a computer (PC).
2. Set the PC to obtain an IP address automatically as shown below.
3. Open the IE Browser and enter the default IP address of the Ethernet
Interface Kit "169.254.1.1" (
show below page:
4. Click the "Network Configuration" on the left side, and input the user &
password. Then click "OK" to proceed.
5. Input the Ethernet parameters in the following page, click "Save Config" to
save the changes.
Note:

To use DHCP, enable the DHCP:
.com
GLOBAL SCIENTIFIC SUPPLY
The Laboratory Supply Company!
EN-7
), the browser will
User: ohaus
Password: ohaus
info@GlobalScientificSupply.com