Cooking Plate; Instructions To User - Diamond G77/2F4T Installations-, Betriebs- Und Wartungsanleitungen

3.2

COOKING PLATE

REPLACING THE PILOT BURNER NOZZLE
N.B.: We advise to first remove the spark plug because it can easily break.
To change the pilot injector, you need to unscrew the nut (Fig. 6 position 7) with a size-10 spanner and replace the injector
(Fig. 6 position 6) with one corresponding to the gas type chosen and shown on Table II Injectors Ch. 2.6.
REPLACING THE PILOT BURNER NOZZLE
Replace the burner nozzle (Fig. 6 position 1) with one corresponding with the gas type chosen and shown on Table II
Injectors Ch. 2.6.
Ignite the pilot burner (Fig. 6 position 5) bringing the knob Fig. 8 to position (
bringing the knob to position 8, loosen the screw (Fig. 6 position 2) and adjust the flame by acting on the adjusting gauge
(Fig. 6 position 3); for each gas type regulate the primary air (R.o.A.) of X mm (see Table II Injectors Ch. 2.6).
REPLACING THE IDLE "BYPASS" SCREW
Replace the idle screw (Fig. 5 position 11) located on the thermostat, with one corresponding to the gas type selected and
following Table II Injectors Ch. 2.6.
Screw the idle bypass screw fully down
After replacing the nozzles, apply on the existing label the one supplied with the machine indicating the new type of gas.
4.
IGNITING THE PILOT BURNER (COOKTOP)
To ignite the plaque pilot, press the knob (Fig. 7) turning it to the left to reach the symbol (
position, press the knob deeply down and ignite the pilot. Keep the knob pressed for approx. 20 seconds; when released, the
pilot flame should stay on. Should it go off, repeat the ignition operation. To ignite the burner, turn the knob to position (
the maximum, and to position (
IGNITING THE COOKING PLATE BURNERS
- To ignite the cooking plate pilot, press the knob (Fig. 8) and rotate it to the left to reach the symbol (
it, press the knob deeply down, at the same time pressing the piezoelectric ignition button; the button is located on the
dashguard. The pilot burner is visible through the peephole on the guard;
- Keep the knob pressed for approx. 20 seconds; on releasing it, the pilot flame should stay on. If the pilot goes off, repeat
the operation.
- To ignite and adjust the burner, turn the knob to the desired position, remembering that the following temperatures
correspond to the positions from 8 to 1:
POS.8 = 300°C
POS.7 = 280°C
POS.6 = 260°C
POS.5 = 240°C
- To shut off the burner, bring the knob back to position (
( ).
GB
) for the minimum. To shut off the burners completely, bring the knob to position (
POS.4 = 220°C
POS.3 = 190°C
POS.2 = 170°C
POS.1 = 150°C
), ignite the burner (Fig. 6 position 4)

INSTRUCTIONS TO USER

); for a total extinguishment, bring the knob back to position
- 20 -
); having reached this
) for
).
); having reached