Installation Place; Positioning; Mounting The Top Units On A Base Or An Extending Support - Diamond G77/2F4T Installations-, Betriebs- Und Wartungsanleitungen

Inhaltsverzeichnis

Verfügbare Sprachen

2.3

INSTALLATION PLACE

- The unit should be installed in adequately ventilated places. (This unit requires a draft of at least 2cu.m/hr l kW T.C.

(Thermal Capacity).

- Install the equipment in compliance with the safety rules applicable in the country where the equipment is installed.

2.4

- The various units may be installed individually or together with other units of our range.

- This unit is not suitable for encasing.

- The distance between side walls must be a minimum of 10cm; should the distance be less or the wall or floor material be

flammable, it is essential to use a thermal insulator.

2.5

All Top units are supplied with height-adjustable feet (P):

- When the unit is to be placed free on a table or a surface,

tighten or loosen the feet (P) as shown in the illustration till it

is perfectly steady, then tighten the locknut (D) so that the foot

is blocked. To prevent slipping, insert the rubber plugs (M)

into the feet's lower holes.

- When the unit is to be fixed to a base or an extending support,

adjust the feet (P) till it is perfectly steady, then tighten the

locknut (D) so that the foot is blocked. Subsequently fasten

from beneath by way of M5 screws (T) and respective washers,

screwing them into the feet as shown in the illustration.

2.6

TABLE II: GAS TECHNICAL DATA, PRESSURE, SMALL BURNER NOZZLES, PILOT ANDIDLE

SCREW FOR GAS COOKTOPS OPTIMA SERIES

Nation

Cat.

and

Nozzle

Inhaltsverzeichnis

G77/6f11t G77/4f7t