Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.6.10. 2T/4T/4S/Spot Welding
The machine works on four modes: 2T cycles, 4T cycles, 4S cycles and spot welding.
2T Cycles
The 2T cycles is provided for short manual welds. For the 2T cycle graphs of current see the picture below.
0~t1: The machine starts to exhale (pre-gas time) When pressing the torch button.
t1~t2: The machine starts to wire feeding.
t2: The machine starts to weld and the current reach to the rated welding current.
t3~t4: When releasing the torch button, the controller automatically stops the welding process, the current goes
to zero, and the machine continue to exhale for some time (post-gas time).
The pre-gas time and post-gas time couldn't be adjusted under 2T cycles mode.
19
Werbung
Inhaltsverzeichnis
