KEENCUT EXCALIBUR 1000X Bedienungsanleitung Seite 16

3.2
1. Move the lower cutting head to the middle of the Main body.
2. Remove the following:
A. One screw from each leg, using 5mm Hexagon wrench.
B. Two sets of Hexagon headed bolts, washers and nuts from the Main body
using 17mm Spanners.
C. Remove small Screw and two Washers from the back of the squaring arm
using 3mm hexagon wrench.
D. Slide off Right hand production stop (this will need to be replaced further on).
Assembly
Preparing to fit the Squaring Arm
3.2