HP DesignJet XL 3600 MFP Serie Einführende Informationen Seite 4

Do not remove or open any closed system covers or plugs.
●
Do not insert objects through slots in the printer.
●
Take care not to trip over the cables when walking behind the printer.
●
Insert the power cord securely and completely into the wall socket and printer inlet.
●
Never handle the power cord with wet hands.
●
Fire hazard
To avoid the risk of fire, take the following precautions:
The customer is responsible for meeting the printer's requirements and the Electrical Code requirements
●
according to the local jurisdiction of the country where the printer is installed. Use the power supply voltage
specified on the nameplate.
Use only the power cord supplied by HP with the printer. Do not use a damaged power cord. Do not use the
●
power cord with other products.
Do not insert objects through slots in the printer.
●
Take care not to spill liquid on the printer. After cleaning, make sure all components are dry before using the
●
printer again.
Do not use aerosol products that contain flammable gases inside or around the printer. Do not operate the
●
printer in an explosive atmosphere.
Do not block or cover the openings of the printer.
●
Mechanical hazard
The printer has moving parts that could cause injury. To avoid personal injury, take the following precautions when
working close to the printer.
Keep your clothing and all parts of your body away from moving parts.
●
Avoid wearing necklaces, bracelets, and other hanging objects.
●
If your hair is long, try to secure it so that it will not fall into the printer.
●
Take care that sleeves or gloves do not get caught in moving parts.
●
Do not operate the printer with covers bypassed.
●
If you need to replace the cutter assembly, remember that the cutter has a sharp cutting edge, and take care
●
not to cut yourself.
Internal fan blades are hazardous moving parts. Disconnect the printer before servicing.
●
Never insert your hands into the printer while it is printing, due to the moving parts inside.
●
Ensure that the anti-tilt supports are assembled for printer use. These supports can only be assembled and
●
removed by service or other authorized personnel.
IMPORTANT:
ENWW
The anti-tilt supports must always be used when printing.
Safety precautions
3