Safety Precautions - HP DesignJet XL 3600 MFP Serie Einführende Informationen

For some countries/regions a printed HP Limited Warranty is provided in the box. In countries/regions where the
warranty is not provided in printed format, you may request a printed copy from
orderdocuments. You can find the Declaration of Conformity by searching for BCLAA-1903 at
certificates.
PostScript is a trademark of Adobe Systems Incorporated.

Safety precautions

Before using your printer, read, understand, and follow these safety precautions, and your local Environmental,
Health, and Safety regulations.
This equipment is not suitable for use in locations where children are likely to be present.
For any maintenance or part replacement, follow the instructions provided in HP documentation to minimize safety
risks and to avoid damaging the printer.
General safety guidelines
There are no operator-serviceable parts inside the printer except those covered by HP's Customer Self Repair
program (see http://www.hp.com/go/selfrepair). Refer servicing of other parts to qualified service personnel.
Turn off the printer and call your service representative in any of the following cases:
The power cord or plug is damaged.
●
The printer has been damaged by an impact.
●
There is any mechanical or enclosure damage.
●
Liquid has entered the printer.
●
There is smoke or an unusual smell coming from the printer.
●
The printer has been dropped.
●
The printer is not operating normally.
●
Turn off the printer in either of the following cases:
During a thunderstorm
●
During a power failure
●
Take special care with zones marked with warning labels.
Ventilation measures for your location, whether office, copy room, or printer room, should meet local environmental
health and safety (EHS) guidelines and regulations.
Electrical shock hazard
The internal circuits of the built-in power supplies and power inlet operate at hazardous voltages
WARNING!
capable of causing death or serious personal injury.
Unplug the printer's power cord before servicing the printer.
The printer requires a building installation circuit breaker, which must meet the requirements of the printer and
should be in accordance with the Electrical Code requirements of the local jurisdiction of the country in which the
equipment is installed.
To avoid the risk of electric shock:
The printer should be connected to earthed mains outlets only.
●
Avoid overloading the printer's electrical outlet with multiple devices.
●
2 HP DesignJet XL 3600 MFP
http://www.hp.com/go/
http://www.hp.eu/
ENWW