Set Up Remote Temperature / Humidity Sensor; Set Up Rain Gauge; Set Up Base Station; Verify Connection - Oregon Scientific WMR88 Bedienungsanleitung

To insert batteries:
1
1. Unscrew the anemometer from the wind sensor
carefully.
2. Insert batteries matching the polarities (+ / -) and
replace the anemometer. Press RESET after each
battery change.
SET UP REMOTE TEMPERATURE / HUMIDITY
SENSOR
The remote sensor can collect data from up to 3 channels.
To set up the remote sensor:
1. Slide open the battery door.
2. Slide channel switch to select a channel (1, 2, 3).
Ensure you use a different channel for each sensor.
3. Insert the batteries, matching the polarities (+ / -).
4. Press RESET after each battery change.
5. Close the battery door.

SET UP RAIN GAUGE

The rain gauge collects rain and takes rainfall readings.
The sensor can remotely transmit data to the base
station.
To set up the rain gauge:
1
1. Remove screws and slide the cover off in an upwards
motion.
2. Insert the batteries (2 x UM-3 / AA), matching the polarities
(+ / -). Press RESET after each battery change.
3
3. Remove the fibre tape.
2
2
4

SET UP BASE STATION

NOTE Install batteries in the remote sensors before the
base station matching the polarities (+ and -).
For continuous use, please install the AC adaptor. The
batteries are for back-up use only.
NOTE Make sure the adaptor is not obstructed and is
easily accessible to the unit.
NOTE The base station and adaptor should not be
exposed to wet conditions. No objects filled with liquid,
such as vases, should be placed on the base station
and adaptor.
To completely disconnect from power, unplug adaptor
from the mains.
To insert batteries:
1. Slide open the battery door.
2. Insert the batteries, matching the polarities (+ / -).
3. Press RESET after each battery change.
4. Close the battery door.
NOTE Do not use rechargeable batteries. It is
recommended that you use alkaline batteries with this
product for longer performance.
NOTE Batteries should not be exposed to excessive
heat such as sunshine or fire.
The battery icon indicator
following areas:
AREA MEANING
Battery in the base station is
Weather Forecast
low.
Area
adaptor is disconnected.
The displayed channel
Temperature or
indicates the outdoor sensor
Humidity Area
for which battery is low.
Wind Speed / Wind
Battery in the wind sensor
Direction / Wind Chil
is low.
Area
UVI / Barometer / Battery in the UV / Rain
Rainfall Area sensor is low.

VERIFY CONNECTION

Before proceeding to install sensors outside, please verify
communication to the base station.
may appear in the
will show when AC