Technical Data; Before Use; Operation; Storage When Not In Use - Silvercrest SCL 5 A1 Bedienungs- Und Sicherheitshinweise

Technical data

General
Sound System:
Power supply:
Weight:
Separating degree:
Signal-to-noise ratio:
Output Power
Subwoofer:
Driver size:
Frequency response
Subwoofer:
Satellite speaker:
Product size (W x H x D)
Subwoofer:
Satellite speaker:
The specification and design may be changed
without notification

Before use

Note:
All parts have to be unpacked and the packaging
material has to be removed completely.
Before use, verify the package contents are
complete and undamaged!
Connections
Please make sure the system and the devices are
power off before connecting.
1. Connect the device PC/CD/MP3/MP4 (not
included), with the 3.5 mm stereo cable on
the rear panel of the subwoofer.
2. Connect the satellite speakers to the 3.5mm
AUX OUTPUT socket on the rear panel of
the subwoofer.
3. Connect the mains plug to the mains socket.
2.1
100 - 240V∼50 Hz
1.70 kg
≥ 45 dB
≥ 72 dB
3 W + 2 x 1 W (RMS)
105 x 105 x 4 5mm x 1
+ 62 x 55 x 35 mm x 2
38Hz - 180Hz
180Hz - 20Hz
160 x 205 x 202mm
79 x 130 x 68mm

Operation

1. After all cables are correctly connected turn
the VOLUME Control to low volume level.
Turn the ON/OFF button which is at the
2.
rear panel of the subwoofer to the ON
position.
When the unit is ON, you can turn the
3.
MAIN and BASS VOLUME controls to
adjust the volume to your desired level.
4. The sound system is now ready to use.

Storage when not in use

Store the product in a dry location to protect it
from dust and direct sunlight.

Cleaning

• Switch the product off, remove all plugs
before cleaning!
• No acid, chafing or solvent cleaning agents
should be used or the product can be
damaged.
• Only clean the outside of the product using
a soft, dry cloth!
• For persistent soiling, a mild cleaning agent
can be used.
• Repair work is also required if the device
is not working properly or has been
dropped. If smoke is produced, or there
are any unusual sounds or smells, turn the
product off immediately. In such cases, the
product should not be used until it has been
inspected by authorised service personnel.
Only have the device repaired by qualified
personnel. Never open the housing of the
product.
• Only use a clean, dry cloth for cleaning the
product and never use any corrosive liquids.
Use a slightly moistened cloth and a mild
cleaning agent to remove stubborn dirt.
GB/IE 17