Electromagnetic Compatibility (Emc) - Makita LD060P Bedienungsanleitung

D
Temperature range:
GB
Storage
Operation
F
* Use a target plate to increase the measurement range
I
during daylight or if the target has poor reflection properties!
E
** in favourable conditions (good target surface properties,
room temperature) up to 10 m. In unfavourable conditions,
NL
such as intense sunshine, poorly reflecting target surface or
high temperature variations, the deviation over distances
P
above 10 m can increase by ± 0.15 mm/m.
N
Electromagnetic Compatibility
FIN
(EMC)
DK
The term "electromagnetic compatibility" is taken to
S
mean the capability of the product to function
TR
smoothly in an environment where electromagnetic
radiation and electrostatic discharges are present,
CZ
and without causing electromagnetic interference to
SK
other equipment.
PL
WARNING
SLO
The Makita LD060P conforms to the most strin-
gent requirements of the relevant standards and
HR
regulations.
H
Yet. the possibility of the product causing interfe-
GR
rence in other equipment cannot be fully excluded.
RUS
LV
EST
LT
ROK
CN
Appendix
FCC statement (applic. in U.S.)
-25°C to +70°C
0°C to +40°C
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful inter-
ference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
•
•
•
•
approved by Makita for compliance could void the
user's authority to operate the equipment.
10
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help
WARNING
Changes or modifications not expressly
Makita LD060P