Switching On/Off; Setting The Instrument - Makita LD060P Bedienungsanleitung

D
abnormal use, and before, during and after important
GB
measurements.
F
Make sure the Makita LD060P optic is kept clean and
that there is no mechanical damage to the bumpers.
I
CAUTION:
E
In using the instrument for distance measure-
NL
ments or for positioning moving objects (e.g. cranes,
P
building equipment, platforms, etc.) unforeseen
events may cause erroneous measurements.
N
Precautions:
FIN
Only use this product as a measuring sensor, not as
DK
a control device. Your system must be configured and
operated in such a way, that in case of an erroneous
S
measurement, malfunction of the device or power
TR
failure due to installed safety measures (e.g. safety
CZ
limit switch), it is assured that no damage will occur.
SK

Switching on/off

PL
1x briefly: the instrument and the laser are swit-
SLO
ched on.
HR
The display shows the battery symbol
H
the next button is pressed.
GR
Pressing this button for longer switches the
RUS
instrument off.
LV
The instrument switches off automatically after
EST
three minutes of inactivity.
LT
ROK
CN
Operation

Setting the instrument

Press long until the desired unit is displayed.
Possible units:
Distance
1. 0.000 m
1
2. 0'0'' /
16
1
3. 0 in /
16
4. 0.00 ft
CLEAR-Key
1x briefly: the last action is cancelled.
Illumination
1x briefly: the display illumination is switched on
or off.
Reference Setting
Default reference setting is from the rear of the
until
instrument.
The instrument can be set for the following measure-
ments:
• To measure from an edge (see drawing {D}), fold
out the stop bracket until it snaps in for the first
time. See drawing {E}.
• To measure out of a corner (see drawing {D}),
fold out the stop bracket until it snaps in, push
4
Area Volume
0.000 m² 0.000 m³
0.00 ft² 0.0 ft³
0.00 ft² 0.0 ft³
0.00 ft² 0.0 ft³
Makita LD060P