HP DESIGNJET L26500 Serie Einführende Informationen Seite 9

Table 1
Error code
32:01.2
32:02
41:03, 42:03
44.n
46:03
61:01
61:09
ENWW
Numeric error messages (continued)
Recommendation
This error occurs when there is a small amount of substrate printed, less than
70 in (178 cm) long. The take-up reel sensor detects that the loop shaper is
(incorrectly) at the bottom of its path, even though the spindle motor has been
rotating for more than 3 seconds. The most probable cause of this error is
that you have forgotten to set the switch direction or tape the substrate to the
spindle core, when the substrate reaches the floor and blocks the take-up
reel's infrared sensors. Check that there is no obstacle between the take-up
reel optical sensors; that the substrate is attached to the take-up reel spindle;
and that the take-up reel switch is in the correct position. If necessary, use the
take-up reel arrow keys to wind the substrate; then press
printing.
This error occurs during printer initialization, to warn you that the take-up reel
has been disconnected while the printer was turned off. It also occurs if you
try to enable the take-up reel, but it is not connected to the printer. Connect
the take-up reel to the printer and press
Turn off the printer using the front panel and the power switch at the rear.
Disconnect the power cords. Open the window and check for any visible
obstacles restricting the movement of the drive roller. If there is a wrinkled
mass of substrate in the substrate path, lift the substrate adjustment lever and
clear the obstruction. Reconnect the power cords and turn the printer on
again.
A switch has failed. There is noise in the signal of the waste management
system. Check that the connector is properly connected.
Turn off the printer using the front panel and the power switch at the rear.
Disconnect the power cords. Reconnect the power cords and turn the printer
on again.
The file format is incorrect and the printer cannot process the job.
The RIP is unable to communicate with the printer. Check that all relevant
cables are properly connected, and check whether the RIP has displayed any
error message.
OK to resume
OK to continue.
Front-panel error messages
7