Product Maintenance; Technical Data - Niko 350-20050 Bedienungsanleitung

350-20050 / 390-20050

5. PRODUCT MAINTENANCE

Dirt can affect the operation of the motion detector. Always keep the lens clean. Use a damp
cloth and water with a little detergent. Never exert pressure on the lens. If the lens or other
parts of the motion detector are defective, the motion detector has to be replaced.

6. TECHNICAL DATA

Input:
supply voltage ........................................... 230V ± 10% 50Hz
power consumption ................................... 1W
Output:
relay contact: ............................................ N.O. max 10A, sensitive to light and motion
Load:
incandescent lamps: .................................. 2300W
halogen 230V: ........................................... 2300W
all low-voltage halogen lamps: ................... 2300VA
fluorescent lamps (non-compensated): ....... 1200VA
max. switching capacity: ............................ 140µF
Max. switch-on peak .................................... 80A/20ms
Operation:
detection angle: ......................................... 180°
detection range: ........................................ semicircle, up to max. 14m
light sensitivity: .......................................... 3lux -infinite
hysteresis on light sensitivity: ..................... +10%
switch-off delay: ........................................ 8s-30min
mounting height : ...................................... 2,5m
Cable inlet: ................................................ 2 x Ø12.5mm
protection degree: ..................................... IP54
operating temperature: .............................. -20 to 45°C
Quality marks: .............................................. CE in compliance with EN 60669-2-1
EN 15