Switching Off; Cleaning And Maintenance; Water Circuit - Dantherm Master CCX 4.0 Bedienungs- Und Wartungsanleitung

en
NOTE: When the control panel
display shows the icon "DROP"
(flashing), accompanied by a beep,
it means that the tank is empty and
must be refilled to reactivate the
"COOL" function.
►►4.3. SWITCHING OFF:
►4.3.1. Press the ON/OFF button to
switch off the appliance (Fig. 9).
►4.3.2. Empty the tank using the drain
cap (Fig. 10-11-12).
►►5. CLEANING AND
MAINTENANCE
WARNING: BEFORE PERFORMING
ANY MAINTENANCE OR REPAIR,
DISCONNECT THE POWER CABLE
FROM THE MAINS.
DEPENDING ON THE ENVIRONMENT
WHERE THE APPLIANCE IS USED,
DUST, DIRT OR WATER QUALITY CAN
AFFECT THE PERFORMANCE OF
THE UNIT. THEREFORE, CLEANING
THE FOLLOWING COMPONENTS
CAN BE NECESSARY:
►►5.1. TANK:
We recommend changing the water
frequently.
►5.1.1. Switch off the appliance and
remove the plug from the mains (Fig.
9-6).
►5.1.2. Remove the drain plug in order
to empty the tank (Fig. 11-12-13).
►►5.2. FILTERS:
It is recommended to clean the filters
frequently.
WARNING: Dirty filters can lead to
a significant drop in performance
of the device.
►5.2.1. Switch off the appliance and
disconnect the plug from the mains
(Fig. 9-6).
Figures and texts of this book are protected by COPYRIGHT.
►5.2.2. Remove the filters upwards
(Fig. 14).
►5.2.3. Clean the filters using a mild
detergent and a clean cloth (Fig. 15).
Ensure the filter is fully dry.
►5.2.4. Place the filter back into its
housing (Fig. 16).
►►5.3. WATER CIRCUIT:
►5.3.1. To ensure proper operation of
the cooler, turn off COOL mode a few
minutes before completely switching
off the appliance, in order to avoid
stagnant water.
►5.3.2. Once a month we recommend
performing a
using clean water and appropriate
disinfection products, running the
cooler outdoors.
complete cycle