Safety Precautions - Philips LTC 0809 Series AutoDome Installationshinweise

SAFETY PRECAUTIONS

CAUTION: TO REDUCE THE RISK OF
ELECTRICAL SHOCK, DO NOT OPEN
COVERS. NO USER SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
This label may appear on the bottom of the unit due to space
limitations.
The lightning flash with an arrowhead symbol,
within an equilateral triangle, is intended to alert
the user to the presence of uninsulated "dangerous
voltage" within the product's enclosure that may
be of sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the
appliance.
WARNING
TO PREVENT FIRE OR SHOCK HAZARD, DO
NOT EXPOSE UNITS NOT SPECIFICALLY
DESIGNED FOR OUTDOOR USE TO RAIN OR
MOISTURE.
Attention: Installation should be performed by
qualified service personnel only in accordance with
the National Electrical Code or applicable local
codes.
Power Disconnect. Units with or without ON-
OFF switches have power supplied to the unit
whenever the power cord is inserted into the
power source; however, the unit is operational
only when the ON-OFF switch is in the ON
position. The power cord is the main power
disconnect for all units.
External Power Supplies
Use only the Recommended Power Supplies.
Power supplies must comply with the
requirements of the latest version of IEC 65/VDE
0860. Substitutions may damage the unit or cause
a fire or shock hazard.
24 VAC Units
Do Not Exceed 30 VAC Input. Voltage applied to the unit's
power input should not exceed 30 VAC. Normal input voltage
is 24 VAC. User supplied wiring from 24 VAC supply to unit
must be in compliance with electrical codes (Class 2 power
levels). Do not ground 24 VAC supply at power supply
terminals or at unit's power supply terminals.
220-240 V, 50 Hz Power Cords
220-240 V, 50 Hz power cords, input and
output, must comply with the latest versions of
IEC Publication 227 or IEC Publication 245.
i.2