Alarm; Pod Informational And Error Messages; Indiglo Night-Light / Night-Mode Feature; Water & Shock Resistance - Timex W243 NA Handbuch

ALARM

Up to three alarms may be set to remind you of upcoming
events.
1. Press MODE until ALARM appears.
2. Press START/SPLIT to select alarm 1, 2, or 3.
3. Press SET to set selected alarm.
4. Hour digits flash. Press + / – to change hour.
5. Press NEXT and + / – to set minutes, AM or PM (if
primary time display is in 12-hour format), DAILY, WEEK-
DAYS, WEEKENDS, or day of the week (weekly alarm).
6. Press DONE to confirm and exit.
7. Press STOP/RESET to turn Alarm ON or OFF.
TIPS:
d
• When Alarm is on, appears in Time display.
• When Alarm sounds, INDIGLO® night-light and alarm icon
flash and alert sounds. Press any button to silence.
• If no button is pushed, alert will cease after 20 seconds
and Backup Alarm will activate after 5 minutes.

POD INFORMATIONAL AND ERROR MESSAGES

v
Blinking antenna icon – The watch is currently searching
for the POD when the wave is blinking. Make sure the POD
is on and within range of the watch.
V
Steady antenna icon – The watch and the POD are com-
municating
o
Steady jogger icon – There is no movement detected
n
Moving jogger icon – Movement has been detected by the
POD and the data is being transmitted to the watch
NO POD DATA – The POD signal was lost. Make sure the
POD is powered on and within range. The watch automati-
cally powers off after 16 hours of continuous use. At that
point, the watch receiver must be turned on again by
pressing ON/OFF.
14
INDIGLO NIGHT-LIGHT / NIGHT-MODE
®
1. Press INDIGLO® button to activate night-light. INDIGLO®
technology illuminates entire watch face at night and in
low light conditions.
2. Continue to press up to 3 seconds to maintain illumina-
tion.
3. Press and hold INDIGLO® button for 4 seconds to
activate NIGHT-MODE® feature.
4. When NIGHT-MODE® feature is activated, push any
button to illuminate watch face for 3 seconds.
5. To deactivate NIGHT-MODE® feature, press INDIGLO®
button for 4 seconds. Feature will automatically
deactivate.
W
WATER & SHOCK RESISTANCE
If your watch is water-resistant, meter marking or (
indicated.
Water-Resistance Depth
30m/98ft
50m/164ft
100m/328ft
*pounds per square inch absolute
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT
PRESS ANY BUTTONS UNDER WATER.
1. Watch is water-resistant only as long as lens, push
buttons and case remain intact.
2. Watch is not a diver watch and should not be used for
diving.
3. Rinse watch with fresh water after exposure to salt
water.
4. Shock-resistance will be indicated on watch face or case-
FEATURE
®
O ) is
p.s.i.a. * Water Pressure
Below Surface
60
86
160
15