Clutch Adjustment - Ingersoll-Rand 1R Serie Technische Produktdaten

EN
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16585820 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size

Clutch Adjustment

Turn off the air supply and disconnect the air supply hose from the Tool before proceeding.
1. Rotate the Adjusting Hole Cover on the Clutch Housing Assembly to expose the adjusting
hole.
2. Rotate the Spindle Assembly or Matched Gear Set until one of the radial holes in the Clutch
Adjusting Nut is visible through the adjusting hole.
3. Insert the No.5C1-416 Clutch Adjusting Key or a 3/32" (2 mm) diameter hardened steel pin or
rod into the hole in the Clutch Adjusting Nut to sprag the Nut against rotation.
4. Grasp the Tool firmly in one hand and rotate the Spindle Assembly or Matched Gear Set to
shift the Clutch Adjusting Nut along the Clutch Driver. Rotating the square drive clockwise
increases the compression on the Clutch Spring and raises the torque at which the clutch will
disengage.
The most satisfactory adjustment is usually obtained by using the tool on the actual
application, and increasing or decreasing the delivered torque until the desired setting
is reached. In any event, it is recommended that the final adjustment be made by gradual
progression.
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - through fitting
11. Grease - disassembly required
WARNING
NOTICE
80167380_ed3