Torque Adjustment - Ingersoll-Rand 1100PS4 Technische Produktdaten

EN
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from valve(s) at low point(s) of piping,
air fi lter and compressor tank daily. Install a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose cou-
pling without internal shut-off , to prevent hose whipping if a hose fails or coupling disconnects. See drawing 16585747 and table on
page 2. Maintenance frequency is shown in a circular arrow and defi ned as h=hours, d=days, and m=months of actual use. Items identifi ed as:
1. Air fi lter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter

Torque Adjustment

See drawing 47132956 on Page 2.
To adjust the torque on these Twin Blade Impulse Wrenches, proceed as follows:
1. Remove the Socket Plug.
2. Rotate the Drive Shaft until the Torque Adjustment Screw is visible in the opening.
3. Using a 1.5 mm hex wrench, rotate the Torque Adjustment Screw clockwise to increase torque. To decrease torque, rotate the Torque
Adjustment Screw counterclockwise.
4. Replace the Socket Plug.
Make all fi nal adjustments at the job.
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Offi ce or Distributor.
EN-2
6. Thread size
7. Coupling
8. Safety Air Fuse
9. Oil
NOTICE
47133053_ed1