Carrier 42NQV050M-Serie Bedienungsanleitung Seite 3

2 PREPARATION BEFORE USE
Preparing Filters
1. Open the air inlet grille and remove the air fi lters.
2. Attach the fi lters. (see detail in the accessory sheet).
Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (–) positions.
Clock Setup
1. Push CLOCK by tip of the pencil.
●
If timer indication is fl ashing, go to the next step 2.
2. Press ON or OFF : adjust the time.
3. Press : Set the time.
Remote Control Reset
1. Remove the battery.
2. Press .
3. Insert the battery.
3 AIRFLOW DIRECTION
1
Press : Move the louver in the
desired vertical direction.
2
Press : Swing the air
automatically and press again to stop.
3
For horizontal direction, adjust
manually.
Note:
• Do not move the louver manually by others.
• The louver may automation positioning by some operation mode.
4 REMOTE CONTROL
1 Infrared signal emitter
2 Start/Stop button (
)
3 Mode select button (
)
4 Temperature button ( )
5 Fan speed button (
)
6 Swing louver button ( )
7 Set louver button (
)
8 On timer button ( ON )
9 Off timer button (
)
OFF
! Sleep timer button (
)
" Setup button (
)
# Clear button (
)
$ Memory and Preset button (
)
% High power button (
)
& Economy button (
)
( Filter reset button ( )
) Clock Reset button ( )
~ Check button ( )
Note: Some models, remote will have text above
the buttons.
AUTOMATIC OPERATION
5
To automatically select cooling, heating, or fan only operation
1. Press : Select A.
2. Press : Set the desired temperature.
3. Press : Select AUTO, LOW , LOW+
or HIGH .
1110650193_EN.indd 3 1110650193_EN.indd 3
6
1. Press
2. Press
3. Press
7
For dehumidifi cation, a moderate cooling performance is controlled
automatically.
1. Press
2. Press
8
To automatically control room temperature and airfl ow for faster cooling or heating
operation (except in DRY and FAN ONLY mode)
Press
9
To automatically control room to save energy (except in DRY and FAN ONLY
mode)
Press
Note: Cooling operation; the set temperature will increase automatically 1 degree/
10
In case of the misplaced or discharged remote control
• Pressing the RESET button, the unit can start or stop
• Operation mode is set on AUTOMATIC operation,
1
11
$
5
4
Set the timer when the air conditioner is operating.
3
2
1
%
6
&
7
#
2
8
9
ON OFF
!
" 3
~
Daily timer allows the user to set both the ON & OFF timers and will be
)
(
activated on a daily basis.
Setting Everyday Timer
1
2
• During the every day timer is activating, both arrows ( , ) are indicated.
Note:
• Keep the remote control in accessible transmission to the indoor unit;
• The setting will be saved for the next same operation.
, MED , MED+ ,
COOLING / HEATING / FAN ONLY OPERATION
: Select Cool , Heat , or Fan only
: Set the desired temperature.
Cooling: Min. 17 o C, Heating: Max. 30 o C, Fan Only:
No temperature indication
: Select AUTO, LOW , LOW+
or HIGH .
DRY OPERATION
: Select Dry .
: Set the desired temperature.
Hi-POWER OPERATION
: Start and stop the operation.
ECO OPERATION
: Start and stop the operation.
hour for 2 hours (maximum 2 degrees increase). For heating operation the
set temperature will decrease.
TEMPORARY OPERATION
without using the remote control.
preset temperature is 25°C and fan operation is
automatic speed.
TIMER OPERATION
Setting the ON Timer
ON
Press : Set the desired ON timer. Press
Press : Set the timer. Press
Press : Cancel the timer. Press
3
ON
Press : Set the ON timer. Press
4
Press
Press : Set the OFF timer.
OFF
mark fl ashing.
otherwise, the time lag of up to 15 minutes will occur.
.
, MED , MED+ ,
EN
ES
FR
IT
DE
PT
PL
CZ
RU
CR
HU
TR
NL
GR
SV
FI
Setting the OFF Timer
NO
OFF
: Set the desired OFF timer.
DK
: Set the timer.
: Cancel the timer.
RO
BG
.
EE
button during the ( or )
LV
SK
SI
8/30/12 11:45 AM 8/30/12 11:45 AM