Beurer HK 70 Gebrauchsanweisung Seite 16

Push the rectangular securing catch through from the front to
the back between the seat and backrest, and orient the securing
catch vertically at the back.
Then attach the clip to the headrest support. To do so, slide the
two ends apart towards the sides, as shown in the diagram.
Then use this opening to guide the clip over the headrest support
so that it can be closed again.
Close the clip by pressing it together until it securely encloses
the headrest support.
The car fastening straps must not cross one another, be entangled, or be mounted with the loop side facing
the seat.
Now take the heat pad in your hand, open the covers of the 4 hook-and-loop points on the rear, hold the
heat pad against your back with the curved side at the level of the lumbar vertebrae, and lean back against
the backrest.
Then check the hook-and-loop connection. If the hook part does not lie fully on the loop part, you can now
correct it, continuing until all 4 points are securely fastened.
You can change the position of the cushion at any time using the hook-and-loop fasteners on the rear of
the heat pad.
Removal of car fastening straps from car seat
To open the clip, slide the two ends apart again towards the sides.
Then push the rectangular securing catch through from the back to
the front between the backrest and the seat.
Car seat
rear
Headrest
support
16