Limits Of Use; Responsibilities; Hazards Of Use - GeoMax Zoom3D Gebrauchsanweisung

Reasonably foreseeable
misuse
1.3

Limits of Use

Environment
DANGER
1.4

Responsibilities

Manufacturer of the
product
Person responsible for
the product
1.5

Hazards of Use

CAUTION
WARNING
WARNING
CAUTION
Safety Directions
• Use of the product without instruction.
• Use outside of the intended use and limits.
• Disabling safety systems.
• Removal of hazard notices.
• Opening the product using tools, for example screwdriver, unless this is permitted for certain functions.
• Modification or conversion of the product.
• Use after misappropriation.
• Use of products with obvious damages or defects.
• Use with accessories from other manufacturers without the prior explicit approval of GeoMax.
• Inadequate safeguards at the working site.
• Deliberate dazzling of third parties.
• Controlling of machines, moving objects or similar monitoring application without additional control
and safety installations.
Suitable for use in an atmosphere appropriate for permanent human habitation: not suitable for use in
aggressive or explosive environments.
Local safety authorities and safety experts must be contacted before working in hazardous areas, or close
to electrical installations or similar situations by the person in charge of the product.
GeoMax AG, CH-9443 Widnau, hereinafter referred to as GeoMax, is responsible for supplying the product,
including the user manual and original accessories, in a safe condition.
The person responsible for the product has the following duties:
• To understand the safety instructions on the product and the instructions in the user manual.
• To ensure that it is used in accordance with the instructions.
• To be familiar with local regulations relating to safety and accident prevention.
• To inform GeoMax immediately if the product and the application becomes unsafe.
• To ensure that the national laws, regulations and conditions for the operation of e.g. radio transmitters
or lasers are respected.
Watch out for erroneous measurement results if the product has been dropped or has been misused, modi-
fied, stored for long periods or transported.
Precautions:
Periodically carry out test measurements, particularly after the product has been subjected to abnormal
use and before and after important measurements.
During dynamic applications, for example stakeout procedures there is a danger of accidents occurring if
the user does not pay attention to the environmental conditions around, for example obstacles, excava-
tions or traffic.
Precautions:
The person responsible for the product must make all users fully aware of the existing dangers.
Inadequate securing of the working site can lead to dangerous situations, for example in traffic, on building
sites and at industrial installations.
Precautions:
Always ensure that the working site is adequately secured. Adhere to the regulations governing safety,
accident prevention and road traffic.
If the accessories used with the product are not properly secured and the product is subjected to mechan-
ical shock, for example blows or falling, the product may be damaged or people can sustain injury.
Precautions:
When setting-up the product, make sure that the accessories are correctly adapted, fitted, secured, and
locked in position.
Avoid subjecting the product to mechanical stress.
en
Zoom3D | 5