Safety Directions; General Introduction; Definition Of Use - GeoMax Zoom3D Gebrauchsanweisung

1

Safety Directions

1.1

General Introduction

Description
About Warning
Messages
1.2

Definition of Use

Intended Use
Safety Directions
The following directions enable the person responsible for the product, and the person who actually uses
the equipment, to anticipate and avoid operational hazards.
The person responsible for the product must ensure that all users understand these directions and adhere
to them.
Warning messages are an essential part of the safety concept of the instrument. They appear wherever
hazards or hazardous situations can occur.
Warning messages...
• make the user alert about direct and indirect hazards concerning the use of the product.
• contain general rules of behaviour.
For the users' safety, all safety instructions and safety messages shall be strictly observed and followed!
Therefore, the manual must always be available to all persons performing any tasks described herein.
DANGER, WARNING, CAUTION and NOTICE are standardized signal words for identifying levels of
hazards and risks related to personal injury and property damage. For your safety it is important to read
and fully understand the table below with the different signal words and their definitions! Supplementary
safety information symbols may be placed within a warning message as well as supplementary text.
Type Description
Indicates an imminently hazardous situation which, if not avoided, will result
DANGER
in death or serious injury.
Indicates a potentially hazardous situation or an unintended use which, if not
WARNING
avoided, could result in death or serious injury.
Indicates a potentially hazardous situation or an unintended use which, if not
CAUTION
avoided, may result in minor or moderate injury.
Indicates a potentially hazardous situation or an unintended use which, if not
NOTICE
avoided, may result in appreciable material, financial and environmental
damage.

Important paragraphs which must be adhered to in practice as they enable the
product to be used in a technically correct and efficient manner.
• 3D measuring of distances, heights, grades, angles, area and volume.
• Manual and automatic measurement of room dimensions.
• Automatic measurement of profiles.
• Laying out points and designs, for example from blueprint.
• Generation of drawings.
• Camera functionality.
• Import/Export of data.
• Administration of data.
en
Zoom3D | 4