CefarCompex CEFAR PERISTIM PRO Gebrauchsanweisung Seite 19

4. Press the PROGRAMMING/CONFIRMATION button
type. You are now moved to the next stage in the programming procedure (see the programming
chart).
5. A preset value is shown on the screen, but you can change it by pressing the INCREASE (OR
DECREASE) button
6. Press the PROGRAMMING/CONFIRMATION button
moved to the next stage (if any) in the programming procedure (see the programming chart).
7. Repeat step 5 and 6 until the value in the last stage is set.
8. The programming procedure is finished and you will automatically exit the programming mode. The
new program is now selected and ready for use. The program is saved for future use.
A custom program can be changed by redoing the programming.
PROGRAMMING CHART
Continuous
(C)
Frequency
Preset: 80 Hz
Range: 2–120 Hz
2–5 Hz
Burst
AUTO
P
. The valid range for this value is shown in the programming chart.
AUTO
P
AUTO AUTO
S
P
Programming
CEFAR PERISTIM PRO
P10, P11, P12
6–120 Hz
Pulse width
Preset: 180 µs
Range: 50–300 µs
AUTO
to confirm your choice of stimulation
S
AUTO
to confirm your setting. You are now
S
Intermittent
(I)
Pulse width
Preset: 180 µs
Range: 50–300 µs
Frequency
Preset: 10 Hz
Range: 5–100 Hz
Stimulation time
Preset: 5 s
Range: 1–20 s
Rest time
Preset: 10 s
Range: 1–30 s
19