Replacement Of Batteries; Replacing The Batteries - CefarCompex CEFAR PERISTIM PRO Gebrauchsanweisung

6. REPLACEMENT OF BATTERIES

A battery symbol is shown on the display when the batteries are almost empty . As long as the
15
stimulator is working normally you can continue the treatment. When stimulation feels weaker than
usual or the stimulator turns off, it is time to replace the batteries.
If the stimulator is not used for some time (approximately 3 months), the batteries should be removed
from the stimulator.
The stimulator operates on either two non-rechargeable 1.5 V AA batteries or two rechargeable 1.2 V AA
batteries, recharged in a separate charger.

REPLACING THE BATTERIES

1. Turn off the stimulator.
2. Locate the battery compartment on the back of the stimulator.
3. Remove the battery cover by sliding it downwards about 1 cm and then lifting it upwards.
4. Remove the batteries.
5. Insert the new batteries correctly according to the polarity markings (+ and –) inside the battery
compartment, see picture.
6. Replace the battery cover.
7. Dispose of the exhausted batteries in accordance with local and national regulations.
NOTE! Non-rechargeable batteries may not be charged due to the risk of explosion.