Using The Appliance; Troubleshooting - Heinner DCH-650TIX Handbuch

www.heinner.com
VI. USING THE APPLIANCE
TOUCH CONTROL WITH LED DISPLAY
1. Press the "Power" button, the button controls the "on" & "off" of the hood.
2. Keep pressing the button "Speed", the motor runs as low / mid / high / low / mid..., the
speed runs circularly; and the LED display will indicate as 1-2-3-1-2... circularly.
3. Press "Light" button, the light is on, press this button again, the light is off, keep
pressing this button, the lights are on/off circularly.
4. When the hood is working, if press the "Timer" button, the hood will go into the status
of acquiescent working (acquiescent time is 9mins), and then, the LED display will
indicate as "9-8-7...-1-0", when indicate "0", the hood will be off automatically. If you
keep pressing "Timer" button, the hood will go in or go out "Timer" function.
VII. TROUBLESHOOTING
FAULT
Light on, but motor does
not work
Light does not work, motor
does not work
Oil leakage
Lights not working
Insufficient suction
The cooker hood inclines
NOTE: Any electrical repairs to this appliance must conform to your local, state and federal
laws. Please contact the service centre if in any doubt before undertaking any of the above.
Always disconnect the unit from the power source when opening the unit.
POSSIBLE CAUSE
Fan switched turned off
Fan switch failed
Motor failed
House fuses blown
Power cord loose
disconnected
One-way valve and the air
ventilation entrance are not
tightly sealed
Leakage from the connection of
U-shaped section and cover
Broken/Faulty globes
The distance between the cooker
hood and the gas top is too far
The fixing screw not tight enough Tighten the hanging screw and
190W, 50Hz, 220-240V
SOLUTION
Select a fan switch position
Contact service center
Contact service center
Reset/Replace fuses
or Refit cord to power outlet.
Switch power outlet on.
Take down the one-way valve
and seal with sealant.
Take U-shaped section down and
seal.
Replace globes as per this
instruction.
Refit the cooker hood to the
correct distance.
make it horizontal
8