Heinner DCH-650TIX Handbuch Seite 12

www.heinner.com
BULB REPLACEMENT

The bulb must be replaced by the manufacturer, its service agent or similarly
qualified persons.

Always switch off the electricity supply before carrying out any operations on the
appliance. When handling bulb, make sure it is completely cool down before any
direct contact to hands.

When handling globes hold with a cloth or gloves to ensure perspiration does not
meet the globe as this can reduce the life of the globe.
CHANGING A LAMP BULB FOR HIGH PRESSURE LED
1. Switch the unit off and pull out the plug first.
2. Wait until the light bulb is cooled down before replacement.
3. Take out the baffle filter and use the screwdriver to take out the frame as the below
pic shows.
4. Replace with same type of bulb (LED 1.5W Max)
Note: Light replacement should have been carried out by qualified service
personnel only.
• ILCOS D code for this lamp is: DSR-1.5/65-S-64
– LED modules –round lamp
– Max wattage: 1.5 W
– Voltage range: DC 12V
– Dimensions:
IMPORTANT
When handling globes hold with a cloth or gloves to ensure perspiration does not meet
the globe as this can reduce the life of the globe.
190W, 50Hz, 220-240V
11