Using The Appliance - Heinner DCH-350RGBK Bedienungsanleitung

www.heinner.com
VI. USING THE APPLIANCE
Push button
1. Push stop button, and the motor will stop.
2. Push the low button, and the motor runs at low speed.
3. Push the middle button, and the motor runs at mid speed.
4. Push the high button, and the motor runs at high speed.
VII. TROUBLESHOOTING
FAULT
Light on, but motor does
not work
Light does not work, motor
does not work
Oil leakage
Lights not working
Insufficient suction
The cooker hood inclines
NOTE: Any electrical repairs to this appliance must conform to your local, state and federal
laws. Please contact the service centre if in any doubt before undertaking any of the above.
Always disconnect the unit from the power source when opening the unit.
Stop Low Mid
POSSIBLE CAUSE
Fan switched turned off
Fan switch failed
Motor failed
House fuses blown
Power cord
disconnected
One-way valve and the air
ventilation entrance are not
tightly sealed
Leakage from the connection of
U-shaped section and cover
Broken/Faulty globes
The distance between the cooker
hood and the gas top is too far
The fixing screw not tight enough Tighten the hanging screw and
65W, 50Hz, 220-240V
Lamp
High
SOLUTION
Select a fan switch position
Contact service center
Contact service center
Reset/Replace fuses
loose or Refit cord to power outlet.
Switch power outlet on.
Take down the one-way valve
and seal with sealant.
Take U-shaped section down and
seal.
Replace globes as per this
instruction.
Refit the cooker hood to the
correct distance.
make it horizontal
7