Maintenance; Cleaning - PureLink CSW200 Benutzerhandbuch

The wireless transmission distance may be too far or blocked by wall or other object. Please
place CSW200 at other location where you can get good signal and video quality.
Please change the direction of Transmitter and Receiver stand to get better reception.
4. If the wireless connection fails:
Please make sure the power of source device which you want to use is turned ON.
Unplug the power cable to restart CSW200.
5. If the TX side is normally playing the video but RX side HDTV has no signal:
Ensure RX side HDTV supports higher or equal resolution.

MAINTENANCE

There are no components located inside the product that require maintenance. Never open or
attempt to dismantle the product.
Maintenance, modifications and repairs are to be performed exclusively by an expert or at a qualified
shop.
If you have questions which remain unanswered by these operating instructions, contact our techni-
cal support service or other technical personnel.

CLEANING

Before cleaning the product, it must be disconnected from all other connected products.
Only use dry and soft cloth to clean the product housing of the.
Do not use abrasives or solvents.
Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as they can
cause damage to the housing or cause malfunctions.
To clean the product, use a soft, dry cloth. Do not apply too much pressure to the housing as this may
cause scratch marks.
You can easily remove dust using a soft bristled brush.
-9-
ENGLISH