Alarm - Dalla Corte DC ONE Benutzerhandbuch

Alarm

This coffee grinder has an electronic control that
checks and signals a series of possible anomalies
due to failures of internal parts or to incorrect use.
ALARM
Data loss
Blocked burr
Broken serial line
Triac board not working
Low tension
Burr cleaning
High internal temperature
High coffee temperature
Blocked gearmotor
Broken hall sensor
Broken NTC probe
Broken Pt1000 probe
38
CAUSe
Big interference on the electric
network
Coffee contains impurities
of significant dimensions
Coffee machine is switched off
or serial cord is unplugged
Failure in grinding motor
Power supply tension problems
A cleaning cycle is necessary
Motor is overheated and/or air
cooling is blocked
Worn out burrs
Gearmotor for grind adjustment
is blocked
Sensor of burrs position is broken
Motor temperature sensor is broken
Coffee temperature sensor is broken
Some of the alarms are designed only to signal
possible failures, others can lock the coffee grinder.
In case an alarm is triggered, do as follows.
SOLUtion
Switch off the grinder, then switch it on again
to go on with work. Contact the technical service
Try the burr cleaning cycle or contact
the technical service
Switch off the grinder, then switch it on again
to go on with work. Contact the technical service
Switch off the grinder, then switch it on again
to go on with work. Contact the technical service
Switch off the grinder, then switch it on again
to go on with work. Contact the technical service
Start the burr cleaning cycle
Switch off the grinder, then switch it on again
to go on with work. Contact the technical service
Switch off the grinder, then switch it on again
to go on with work. Contact the technical service
Switch off the grinder, then switch it on again
to go on with work. Contact the technical service
Switch off the grinder, then switch it on again
to go on with work. Contact the technical service
Switch off the grinder, then switch it on again
to go on with work. Contact the technical service
Switch off the grinder, then switch it on again
to go on with work. Contact the technical service