ASROCK K10N780SLIX3-WiFi Bedienungsanleitung Seite 30

HDMI_SPDIF Cable
(Optional)
A. black end
2.9 HDMI_SPDIF Header Connection Guide 2.9 HDMI_SPDIF Header Connection Guide 2.9 HDMI_SPDIF Header Connection Guide 2.9 HDMI_SPDIF Header Connection Guide 2.9 HDMI_SPDIF Header Connection Guide
HDMI (High-Definition Multi-media Interface) is an all-digital audio/video specification,
which provides an interface between any compatible digital audio/video source, such as
a set-top box, DVD player, A/V receiver and a compatible digital audio or video monitor,
such as a digital television (DTV). This motherboard is equipped with a HDMI_SPDIF
header, which provides SPDIF audio output to HDMI VGA card, allows the system to
connect HDMI Digital TV/projector/LCD devices. To use HDMI function on this
motherboard, please refer to page 36 of "User Manual" in the support CD for detailed
installation procedures.
2.10 eSA 2.10 eSA 2.10 eSAT T T T T AII Inter 2.10 eSA 2.10 eSA AII Inter AII Inter AII Inter face Introduction AII Inter
NOTE:
1. If you set "SATA Operation Mode" option in BIOS setup to AHCI or RAID mode, Hot
Plug function is supported with eSATAII devices. Therefore, you can insert or remove
your eSATAII devices to the eSATAII ports while the system is power-on and in
working condition.
2. If you set "SATA Operation Mode" option in BIOS setup to non-RAID mode, Hot Plug
function is not supported with eSATAII devices. If you still want to use eSATAII
function in non-RAID mode, please insert or remove your eSATAII devices to the
eSATAII ports only when the system is power-off.
3. If you want to use the eSATAII HDD as an OS disk, please set "SATA Operation
Mode" option in BIOS setup to non-RAID mode. If you want to use the eSATAII HDD
as a removable data disk, please set "SATA Operation Mode" option in BIOS setup
to RAID mode. If you want to add the eSATAII HDD as a RAID disk, please set "SATA
Operation Mode" option in BIOS setup to RAID mode.
4. Please do not configure your eSATAII HDD as a RAID disk; otherwise, it may affect
the Hot Plug function that eSATAII HDD should have.
5. Please refer to page 32 to 34 for detailed information of RAID mode, non-RAID
mode and AHCI mode.
3 0 3 0 3 0
3 0 3 0
ASRock
Please connect the black end (A)
of HDMI_SPDIF cable to the
C
B HDMI_SPDIF header on the
motherboard. Then connect the
A
white end (B or C) of
HDMI_SPDIF cable to the
HDMI_SPDIF connector of HDMI
VGA card.
B. white end (2-pin)
face Introduction face Introduction face Introduction face Introduction
K10N780SLIX3-WiFi Motherboard
C. white end (3-pin)