ASROCK K10N780SLIX3-WiFi Bedienungsanleitung Seite 25

2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2, No. 28)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2, No. 9)
connect the blue end
to the motherboard
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATA II Connectors
(SATAII_1 (PORT0):
SATAII_1 SATAII_3
see p.2, No. 23)
(PORT0)
(SATAII_2 (PORT1):
see p.2, No. 20)
(SATAII_3 (PORT2):
see p.2, No. 14)
SATAII_2 SATAII_4
(SATAII_4 (PORT3):
(PORT1)
see p.2, No. 18)
(SATAII_5 (PORT4):
see p.2, No. 15)
(SATAII_6 (PORT5):
see p.2, No. 16)
SATAII_6 (PORT5) connector can be used for internal storage device
or be connected to eSATAII connector to support eSATAII device.
Please read "eSATAII Interface Introduction" on page 30 for details
about eSATAII and eSATAII installation procedures.
ASRock
80-conductor ATA 66/100/133 cable
These six Serial ATAII
(SATAII) connectors support
SATA data cables for internal
SATAII_5
(PORT2) (PORT4)
storage devices. The current
SATAII interface allows up to
3.0 Gb/s data transfer rate.
SATAII_6
(PORT3) (PORT5)
K10N780SLIX3-WiFi Motherboard
the red-striped side to
Pin1
connect the black end
to the IDE devices
2 5 2 5 2 5
2 5 2 5