Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Figure 6. Under Shelf Mounting
with Angle Brackets
POST MOUNT
(Consult Factory)
DUAL MOUNTING
(see Figure 7)
Glo-Ray Warmers can be mounted side-by-side,
providing a space of not less than 3" (7,6 cm) is
maintained between units.
Factory ordered dual models are shipped with either
a 3" or 6" (7,6 or 15,2 cm) wide spacer, with or with-
out lights. These dual mount spacers are available for
aluminum models only. Consult factory before
installing warmers side-by-side without spacers.
6"
(15,2 cm)
DUAL WITH 3" (7,6 cm) SPACER
18" (45,7 cm)
6"
(15,2 cm)
DUAL WITH 6" (15,2 cm) SPACER
Figure 7. Dual Mounting
CAUTION
Installation of two or more warmers with less than 3"
(7.6 cm) between housings could result in premature
failure of component parts.
Glo-Ray
15" (38 cm)
3"
6"
(7,6 cm)
(15,2 cm)
6"
6"
(15,2 cm)
(15,2 cm)
®
Food Warmer
CLEANING
WARNING
The appliance is not of jet-proof construction.
Do not use jet-clean spray to clean this appliance.
To preserve the finish of your Glo-Ray Food Warmer
it is recommended that exterior surfaces be wiped
daily with a damp cloth. Stubborn stains may be
removed with a good aluminum or stainless steel
cleaner or a non-abrasive cleanser.
CAUTION: Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of the Foodwarmer
marring its appearance and making it susceptible to
soil accumulation.
Breath protectors may be removed for thorough
cleaning and polishing. They should be wiped daily
with a soft, damp cloth. If fine scratches are present
a good acrylic cleaner may be used to polish the
breath protectors and remove the scratches.
CAUTION: Only soft cleaning cloths should be used
to clean breath protectors. Breath protectors are
made of shatter-proof acrylic and will scratch if proper
care is not taken.
DISPLAY LIGHT BULB REPLACEMENT
The display light is an incandescent bulb which
illuminates the warming area. This bulb has a special
coating to guard against injury and food contamination
in the event of breakage.
To replace a bulb, disconnect the power supply and
wait until the unit has cooled. Display lamps have
a threaded base. Unscrew the bulb from the unit and
replace it with a new specially coated incandescent
bulb. Hatco Shatter-Resistant Bulbs meet NSF
standards for food holding and display areas.
SAFETY PRECAUTIONS
Do not add a decorative soffit to hide a pass-through
mounted Glo-Ray.
Use only recommended mounting methods and mate-
rials and approved accessories to prevent personal
injury or damage to the unit.
Be certain that specified safe and proper distances
are maintained between the Glo-Ray and combustible
wall or wall type surfaces and counters.
See LOCATION.
4
Werbung
Inhaltsverzeichnis
