Herunterladen Inhalt Inhalt Diese Seite drucken

Important Safety Information; Electric Shock Hazard; Fire Hazard; Important Safety Instructions - Hatco GLOMAX GMFFL Installations- Und Bedienungshandbuch

Tragbare speisenwärmer
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 11
Read the following important safety information before using this equipment to avoid serious injury or death and
to avoid damage to equipment or property.
WARNING

ELECTRIC ShOCk hAzARD:

• Plug unit into a properly grounded electrical outlet of
the correct voltage, size, and plug configuration. If the
plug and receptacle do not match, contact a qualified
electrician to determine and install the proper voltage
and size electrical outlet.
• Turn power switch OFF, unplug power cord, and allow
unit to cool before performing any maintenance or
cleaning.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Unit is not weatherproof. Locate the unit indoors where
the ambient air temperature is a minimum of 21°C
(70°F).
• Do not steam clean or use excessive water on the unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Never overload extension cord. If extension cord feels
hot, turn off unit immediately and replace with cord that
has larger current carrying capacity.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or worn.
• Do not attempt to repair or replace a damaged power
cord. The cord must be replaced by hatco, an Authorized
hatco Service Agent, or a person with similar
qualifications.
• Use only Genuine hatco Replacement Parts when
service is required. Failure to use Genuine hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in hatco equipment.

FIRE hAzARD

• Locate the unit a minimum of 25 mm (1") from
combustible walls and materials. If safe distances are
not maintained, combustion or discoloration could
occur.
• Base must be secured to top housing before turning on
power.
Form No. GMFFLCEM-0810

IMPORTANT SAFETy INFORMATION

Use only light bulbs that meet or exceed National
Sanitation Foundation (NSF) standards and are specifically
designed for food holding areas. Breakage of light bulbs
not specially coated could result in personal injury and/or
food contamination.
Make sure all operators have been instructed on the safe
and proper use of the unit.
This unit is not intended for use by children or persons
with reduced physical, sensory, or mental capabilities.
Ensure proper supervision of children and keep them away
from the unit.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized hatco Service
Agent or contact the hatco Service Department at 414-671-
6350; fax 414-671-3976.
BURN hAzARD: Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
Locate the unit at the proper counter height in an area that
is convenient for use. The location should be level to
prevent the unit or its contents from falling accidentally and
strong enough to support the weight of the unit and
contents.
Do not move or relocate unit when it contains food product.
Turn off unit, remove food product, and allow to cool
completely before moving or cleaning.
Standard and approved manufacturing oils may smoke up
to 30 minutes during initial startup. This is a temporary
condition. Operate unit without food product until smoke
dissipates.
This unit is designed and recommended for use on metallic
countertops. Damage to non-metallic countertop material is
not covered under the hatco warranty. For other
countertop material, verify with manufacturer that material
is suitable for temperatures up to 100°C (212°F).
Use non-abrasive cleaners only. Abrasive cleaners could
scratch the finish of the unit, marring its appearance and
making it susceptible to soil accumulation.
Clean unit daily to avoid malfunctions and maintain
sanitary operation.
3
WARNING
CAUTION
NOTICE

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis